Thermal properties and calcium-magnesium-alumino-silicate (CMAS) interaction of novel γ-phase ytterbium-doped yttrium disilicate (γ-Y1.5Yb0.5Si2O7) environmental barrier coating material
- Buhao Zhang(corresponding author),
- Hangfeng Zhang,
- Mingwen Bai,
- Aochen Du,
- Ebenezer B. Owusu,
- Alex Lynam
- University of Nottingham,
- Queen Mary University of London,
- University of Leeds,
- Fuzhou University,
- Thermal Spray Innovations
Research Output:
Contribution to journal
Article
Research
Peer-reviewOpen access
Abstract
<p>Rare-earth disilicates are promising candidates for thermal and environmental barrier coatings (TEBC) in gas turbines that safeguard SiC<sub>f</sub>/SiC ceramic matrix composites (CMCs) from thermal degradation and environmental attacks. Here, we report a systematic investigation on novel TEBC material, γ-Y<sub>1.5</sub>Yb<sub>0.5</sub>Si<sub>2</sub>O<sub>7</sub>. The γ-phase quarter molar ytterbium–doped yttrium disilicate exhibited low thermal conductivity (1.72 W·m<sup>−1</sup>·K<sup>−1</sup> at 1200 °C) and reduced intrinsic thermal expansion (3.17 ± 0.22 × 10<sup>−6</sup> K<sup>−1</sup> up to 1000 °C), ensuring promisingly effective thermal insulation and minimized thermal stress with CMC substrates. Using density functional theory (DFT), the heat capacity of γ-Y<sub>1.5</sub>Yb<sub>0.5</sub>Si<sub>2</sub>O<sub>7</sub> was predicted higher than that of undoped γ-Y<sub>2</sub>Si<sub>2</sub>O<sub>7</sub>. Comparing these predictions to results calculated using the Neumann–Kopp (NK) rule revealed only minor variations. A metastable CMAS interaction byproduct, cyclosilicate phase Ca<sub>3</sub>RE<sub>2</sub>(Si<sub>3</sub>O<sub>9</sub>)<sub>2</sub>, was identified based on energy dispersive X-ray spectrometer (EDS) and electron backscatter diffraction (EBSD) techniques, appearing at 1300 °C but disappearing at 1400 °C. The γ-Y<sub>1.5</sub>Yb<sub>0.5</sub>Si<sub>2</sub>O<sub>7</sub> exhibited good CMAS resistance on both dense pellets and sprayed coatings, forming a protective apatite (Ca<sub>2</sub>RE<sub>8</sub>(SiO<sub>4</sub>)<sub>6</sub>O<sub>2</sub>) interlayer that effectively hindered CMAS infiltration at evaluated temperatures. The relatively higher Y:Yb atomic ratio (> 3) in the apatite grains indicate differential reactivity with molten CMAS and provides crucial insights into the CMAS corrosion mechanism. These findings highlight the potential of γ-Y<sub>1.5</sub>Yb<sub>0.5</sub>Si<sub>2</sub>O<sub>7</sub> as a CMC coating material, emphasizing the need for tailored microstructural optimization as a thermal sprayed coating to enhance long-term performance in extreme gas turbine environments.</p>
Research Output Information
Output type
Research Output:
Contribution to journal
Article
Research
Peer-reviewOriginal language
EnglishArticle number
64Journal (Volume, Issue Number)
Advanced Composites and Hybrid Materials (Volume 7, Issue 2)Publication milestones
- Published - 04/2024
Publication status
Published - 04/2024
ISSN
2522-0128Publication IDs
- Scopus: 85189155883
Publication metrics
Metrics
SciVal
FWCI
1.27
SciVal
Author count
9
SciVal
Paper percentile
77
SciVal
citations
13
Download statistics
Download count
3
PlumX, opens in new tab
Captures
16
Citation count
13
