Saltar a casilla de búsquedaSaltar a navegaciónIr directamente al contenido principal

A facile low temperature synthesis of TiO2 nanorods for high efficiency dye sensitized solar cells

  • A. E. Shalan(autor correspondiente)
    ,
  • M. M. Rashad
    ,
  • Youhai Yu
    ,
  • Mónica Lira-Cantú
    ,
  • M. S.A. Abdel-Mottaleb
*Autor correspondiente de este trabajo
  • Central Metallurgical Research & Development Institute
    ,
  • CSIC
    ,
  • Ain Shams University
Publicación:
Contribución a una revista
Artículo
Investigación
Revisión por expertos

Abstract

Titania (TiO2) nanorods have been synthesized with controlled size for dye-sensitized solar cells (DSSCs) via hydrothermal route at low hydrothermal temperature of 100 C for 24 h. The titania nanorods were characterized using XRD, SEM, TEM/HRTEM, UV-vis Spectroscopy, FTIR and BET specific surface area (S BET), as well as pore-size distribution by BJH. The results indicated that the bulk traps and the surface states within the TiO2 nanorods films have enhanced the efficiency of DSSCs. The size of the titania nanorods was 6.7 nm in width and 22 nm in length. The high surface area can provide more sites for dye adsorption, while the fast photoelectron-transfer channel can enhance the photogenerated electron transfer to complete the circuit. The specific surface area S BET was 77.14 m2 g-1 at the synthesis conditions. However, the band gap energy of the obtained titania nanorods was 3.2 eV. The oriented nanorods with appropriate lengths are beneficial in improving the electron transport property and thus leading to the increase of photocurrent, together enhancing the power conversion efficiency. A nearly quantitative absorbed photon-to-electrical current conversion achieved upon excitation at wave length of 550 nm and the power efficiency was enhanced from 5.6 % for commercial TiO2 nanoparticles Degussa (P25) cells to 7.2 % for TiO2 nanorods cells under AM 1.5 illumination (100 mW cm-2). The TiO2 cells performance was improved due to their high surface area, hierarchically mesoporous structures and fast electron-transfer rate compared with the Degussa (P25).

Research Output Information

Tipo de resultado

Publicación:
Contribución a una revista
Artículo
Investigación
Revisión por expertos

Idioma original

Inglés

Páginas desde-hasta (Número de páginas)

Páginas 111-122 (12 páginas)

Revista (Volumen, Número de Edición)

Applied Physics A: Materials Science and Processing (Volumen 110, Número 1)

Hitos de publicación

  • Publicada - 01/2013

Estado de publicación

Publicada - 01/2013

ISSN

0947-8396

ID de publicación

  • Scopus: 84872316181

Funding Details

This work was financially supported by the Academy of Scientific Research and Technology (ASRT) and Ministry of Scientific Research of Egypt. Ahmed Shalan acknowledges Prof. Monica Lira and her lab in Centre de Investigacio en Nanociencia I Nanotecnologia (Cin2, CSIC), ETSE, Campus UAB, Bellaterra (Barcelona), Spain for their support and helping in pursue part of the experimental section.
FundersFunding numbers
ASRT
-
MSR
-

Sustainable Development Goals

  • ODS 7: Energía asequible y no contaminante
    ODS 7: Energía asequible y no contaminante

Publication metrics

Métricas

SciVal
citaciones
47
SciVal
FWCI
2.19
SciVal
Número de autores
5
SciVal
Percentil de artículo
88

PlumX, se abre en una pestaña nueva

Capturas
46
Menciones
1
Número de citas
48