Saltar a casilla de búsquedaSaltar a navegaciónIr directamente al contenido principal

Distinction between SnO2 nanoparticles synthesized using co-Precipitation and solvothermal methods for the photovoltaic efficiency of dye-sensitized solar cells

  • M. M. Rashad
    ,
  • I. A. Ibrahim
    ,
  • I. Osama
    ,
  • A. E. Shalan(autor correspondiente)
*Autor correspondiente de este trabajo
  • Central Metallurgical Research & Development Institute
    ,
  • Friedrich-Alexander University Erlangen-Nürnberg
Publicación:
Contribución a una revista
Artículo
Investigación
Revisión por expertos

Abstract

<p>Nanocrystalline SnO<sub>2</sub> powders prepared by solvothermal and co-precipitation pathways have been characterized using XRD, TEM, UV-Visible absorption, BET specific surface area (SBET) method, EIS and J-V measurements. The obtained powders have a surface area and size of 38·59 m <sup>2</sup>/g and 10·63 nm for the SnO<sub>2</sub> powders synthesized solvothermally at a temperature of 200 °C for 24 h, while the values were 32·59 m<sup>2</sup>/g and 16·20 nm for the formed hydroxide precursor annealed at 1000 °C for 2 h by co-precipitation route. The microstructure of the formed powders appeared as tetragonal-like structure. Thus, the prepared SnO<sub>2</sub> nanopowders using two pathways were applied as an electrode in dye-sensitized solar cell (DSSC). The photoelectrochemical measurements indicated that the cell presents short-circuit photocurrent (Jsc), open circuit voltage (Voc) and fill factor (FF) were 7·017 mA/cm <sup>2</sup>, 0·690 V and 69·68%, respectively, for solvothermal route and they were 4·241 mA/cm<sup>2</sup>, 0·756 V and 66·74%, respectively, for co-precipitation method. The energy conversion efficiency of the solvothermal SnO<sub>2</sub> powders was considerably higher than that formed by co-precipitation powders; ~ 3·20% (solvothermal) and 2·01% (co-precipitation) with the N719 dye under 100 mW/cm<sup>2</sup> of simulated sunlight, respectively. These results were in agreement with EIS study showing that the electrons were transferred rapidly to the surface of the solvothermal-modified SnO<sub>2</sub> nanoparticles, compared with that of a co-precipitation-modified SnO<sub>2</sub> nanoparticles.</p>

Research Output Information

Tipo de resultado

Publicación:
Contribución a una revista
Artículo
Investigación
Revisión por expertos

Idioma original

Inglés

Páginas desde-hasta (Número de páginas)

Páginas 903-909 (7 páginas)

Revista (Volumen, Número de Edición)

Bulletin of Materials Science (Volumen 37, Número 4)

Hitos de publicación

  • Publicada - 06/2014

Estado de publicación

Publicada - 06/2014

ISSN

0250-4707

ID de publicación

  • Scopus: 84903315974

Sustainable Development Goals

  • ODS 7: Energía asequible y no contaminante
    ODS 7: Energía asequible y no contaminante

Publication metrics

Métricas

SciVal
citaciones
49
SciVal
FWCI
0.97
SciVal
Número de autores
4
SciVal
Percentil de artículo
71

PlumX, se abre en una pestaña nueva

Número de citas
49
Menciones
1
Capturas
48