Suitability of the measurement techniques of oxygen permeability in order to predict corrosion rates of concrete rebars
- C. Andrade,
- C. Alonso,
- ,
- M. Garcia
- CSIC,
- The Institute E. Torroja
Abstract
Synopsis: The air or oxygen permeability of concrete is usually measured by means of techniques which utilize mechanical driving forces. Thus, air or oxygen is forced to pass through a piece of concrete using different mechanical pressures. The flow of gas so measured is used as an indication of concrete permeability and sometimes is also used to predict the durability of concrete reinforcements based in the relationship between anodic corrosion rate and amount of oxygen which may be reduced in the cathodic areas. However, this extrapolation may lead to erroneous conclusions because a dry concrete allows a higher amount of oxygen to pass through it than a wet one, although the corrosion rate should be much lower in dry than in wet concrete. In the present paper, comparisons between flow of oxygen measured in paste, mortar and concrete specimens held at different relative humidities using electrochemical driving forces (polarization at about -750 mV SCE) and corrosion rates (measured by means of the Polarization Resistance) are presented in order to discuss the relationship between both. The results show that the oxygen permeability is only dependent of the amount of electrolyte inside the pores, but the corrosion rate is also dependent of the concrete resistivity which is fixed by the amount of pore water content.
Research Output Information
Tipo de resultado
Idioma original
InglésPáginas desde-hasta (Número de páginas)
Páginas 45-60 (16 páginas)Hitos de publicación
- Publicada - 01/06/1990
Estado de publicación
Editorial
American Concrete Institute, Estados UnidosSerie de publicación
- Nombre de serie de publicación: American Concrete Institute, ACI Special Publication
ISSN (Impreso): 0193-2527
Volumen: SP-122
ISBN (electrónico)
9780870316203ID de publicación
- Scopus: 85114363313
Título de publicación principal
Paul Klieger Symposium on Performance of ConcreteEditores de publicación principal
- David Whiting
